Nice Wingo 5 Kit WINGO5KIT for 3.5 m Swing Gates in Oman
Nice Wingo 5 kit (WINGO5KIT) for a two leaf gate up to 3.5 m per leaf: two WG5000 230V motors with 1700 N, the MC800 control unit, two remotes, a receiver, EPM photocells, an LED flashing light, a push button and brackets.
OMR 190.000, in stock in Muscat, with fitting across Oman.
Description
The Nice Wingo 5 kit (Nice WINGO5KIT, also coded WINGO5BDKCE) is a complete kit for a large villa gate with a 3.5 m swing gate leaf on each side. It uses two Nice WG5000 motors with 1700 N of force, run by the Nice MC800 control unit, and comes with two remotes, a receiver, a pair of EPM photocells, an LED flashing light, a push button and mounting brackets.
It covers the wider 3.5 m swing gate that the smaller Wingo 4 kit cannot, at a price well below the Toona range.
What is in the Nice Wingo 5 kit?
| In the kit | What it does |
|---|---|
| Two Nice WG5000 motors, 230V | One arm for each leaf, up to 3.5 m per leaf |
| Nice MC800 control unit | Runs both motors, automatic closing and pedestrian opening |
| Two Nice remote controls | Open and close the gate from the car |
| Nice radio receiver | Plugs into the control unit and receives the remotes |
| One pair of Nice EPM photocells | Stop the gate closing on a car or a person |
| LED flashing light | Warns that the gate is moving |
| Push button | Opens the gate from inside |
| Motor mounting brackets | Fix each motor to the pillar and to the leaf |
The Nice WINGO5KIT is complete for a standard two leaf gate. A keypad, an intercom or a GSM opener can be added to the control unit later.
Nice Wingo 5 kit price in Oman
Price: OMR 190.000 for the complete Nice Wingo 5 kit, in stock at our shop in Al Khuwair, Muscat. Installation is quoted after we see the gate.
Nice WG5000 technical data
| Data | Value |
|---|---|
| Kit code | Nice WINGO5KIT, WINGO5BDKCE |
| Motors | Two Nice WG5000 |
| Maximum leaf length | 3.5 m per leaf |
| Supply | 230V AC, 50 Hz |
| Power per motor | 200 W, 1.5 A |
| Maximum force | 1700 N |
| Speed | 0.013 m per second |
| Work cycle | 30 cycles per hour |
| Control unit | Nice MC800 |
| Opening stop | Pre assembled mechanical stop |
| Manual release | Personalised Nice key |
| Protection rating | IP44 |
| Working temperature | Minus 20 to plus 50°C |
These figures come from the supplier listing of the Nice data. The Nice WG5000 has more force and a longer reach than the WG4000 in the Wingo 4 kit.
Built for a 3.5 m swing gate
Many villa gates in Oman are wider than the 2 m per leaf that a small motor can handle. A 3.5 m swing gate leaf needs more reach and more push, and the Nice WG5000 gives both: 1700 N of force from a slim arm that still fits a normal pillar.
| Your gate | Our advice |
|---|---|
| Leaves up to 2 m each | The Nice Wingo 4 kit is enough |
| Leaves from 2 to 3.5 m each | The Nice Wingo 5 kit is the right size |
| Leaves up to 4 m, or very heavy steel | Choose the Nice Toona 4 |
| Leaves up to 5 m | Choose the Nice Toona 5 |
A solid steel 3.5 m swing gate leaf is heavy and catches the wind, so we check the hinges, the pillars and the gate weight on site before we confirm the kit. See all our Nice swing gate motors.
Nice Wingo 5 kit or the Wingo 4 kit
| Nice Wingo 5 kit | Nice Wingo 4 kit | |
|---|---|---|
| Motors | Two WG5000 | Two WG4000 |
| Leaf length | Up to 3.5 m | Up to 2 m |
| Force | 1700 N | 1500 N |
| Control unit | MC800 | MC800 |
| Price | OMR 190.000 | OMR 180.000 |
For only OMR 10 more, the Wingo 5 kit takes leaves almost twice as long. If your leaves are close to 2 m, the extra margin of the Nice WG5000 is worth it for a large villa gate that runs every day.
The MC800 control unit
On a large villa gate, the MC800 runs both WG5000 motors with a delay between the leaves, so they close in the right order and overlap correctly. It learns the gate on its own, sets the pause before automatic closing, shows fault codes, and gives pedestrian opening on one leaf for people on foot. It also accepts GSM openers, WiFi controllers, RFID readers, keypads and intercoms.
How we install the Nice WINGO5KIT
- We check the hinges first: each 3.5 m leaf must swing freely by hand before the motors go on.
- We measure each pillar and set the bracket positions for the right opening angle.
- We fix both motors; the opening stops are pre assembled, so we set the closing stops.
- We fit the MC800, the EPM photocells, the LED flashing light and the push button.
- We pair both remotes, run the learning cycle, set the leaf delay and the pause, and test the photocells while the gate closes.
The Wingo 5 kit in the Oman heat, sand and salt
| Problem | What helps |
|---|---|
| Summer heat on the motors | Rated to plus 50°C; keep the hinges free running |
| Wind on a wide solid leaf | Check the pillars and brackets at every service |
| Sand on the arms and photocells | Clean the arms and lenses at every service |
| Salt air in Sohar, Sur, Salalah and Duqm | Service coastal sites more often and grease the arms |
| Power cuts | Open each leaf by hand with the personalised Nice key |
A large villa gate with long leaves works its hinges hard, so we grease and check them at every service visit.
Nice Wingo 5 kit specification
| Kit | Nice WINGO5KIT, WINGO5BDKCE |
|---|---|
| Sold as | Kit: 2 WG5000 motors, MC800, 2 remotes, receiver, EPM photocells, LED flashing light, push button, brackets |
| Gate | Two leaves, up to 3.5 m each, for a large villa gate |
| Supply and power | 230V AC, 200 W per motor |
| Force and speed | 1700 N, 0.013 m/s |
| Work cycle | 30 cycles per hour |
| Protection and temperature | IP44, minus 20 to plus 50°C |
| Price | OMR 190.000 |
Supply and fitting across Oman
We are a physical shop in Al Khuwair, Muscat with our own engineers. They supply, fit and service Nice gate automation across all eleven governorates: Muscat, Al Batinah North, Al Batinah South, Ad Dakhiliyah, Ash Sharqiyah North, Ash Sharqiyah South, Adh Dhahirah, Al Buraimi, Al Wusta, Dhofar and Musandam. That reaches Sohar in Al Batinah North, Nizwa in Ad Dakhiliyah, Sur in Ash Sharqiyah South, Salalah in Dhofar and Duqm in Al Wusta.
Visit us at Shop No 176, Way Street No 57, Block No 17/2, Al Khuwair, Muscat, Oman. Call or WhatsApp +968 78109286, or email contact@doorsauto.com. Send us the leaf width and a photo of the gate and pillars, and we confirm the right kit before you pay.
Nice Wingo 5 kit FAQ
What is the Nice Wingo 5 kit?
The Nice WINGO5KIT: a complete kit with two WG5000 motors and the MC800 control unit, for a two leaf gate with leaves up to 3.5 m each.
What is in the Nice WINGO5KIT?
Two WG5000 motors, the MC800 control unit, two remotes, a receiver, a pair of EPM photocells, an LED flashing light, a push button and mounting brackets.
What is the difference between the Wingo 5 kit and the Wingo 4 kit?
The Wingo 5 kit uses the WG5000 for leaves up to 3.5 m with 1700 N. The Wingo 4 kit uses the WG4000 for leaves up to 2 m.
Is the Nice WG5000 strong enough for a large villa gate?
Yes, for a 3.5 m swing gate leaf. For longer or very heavy leaves, choose the Nice Toona 4 or Toona 5.
What is the Nice Wingo 5 kit price in Oman?
OMR 190.000 for the complete kit, in stock at our Muscat shop. Installation is quoted after we see the gate.
NICE WINGO5KIT Specifications
- Brand: NICE
- Model: WINGO5KIT
- Product Type: Swing Gate Motor
- Capacity: Standard residential and commercial installations
- Build: reinforced metal casing
- Application: commercial compounds and warehouses
- Availability: In stock in Oman, delivery nationwide







Reviews
There are no reviews yet.